VIKING gear pump It is a commonly used centrifuge Gear pump It is mainly used to transport various non corrosive low and medium viscosity liquids. In order to ensure the normal operation of the gear pump and extend its service life, regular maintenance is required. The following are some common maintenance methods for VIKING gear pump.

Clean the gear pump housing: regularly clean the pump housing and accessories to remove dust, oil and debris. You can use a soft cloth and detergent to wipe, and pay special attention not to use aggressive detergent.

Check the lubricating oil: the operation of the gear pump needs the support of lubricating oil, so it is very important to check the lubricating oil. Regularly check the oil level and quality of lubricating oil to ensure that the oil level is within the standard range and the oil quality is clean. If the oil is deteriorated or excessive, it shall be replaced and cleaned in time.

Check the seal: the seal of the gear pump is an important part to ensure the operation of the pump. Regularly check the wear of seals to ensure that they are intact and effective. In case of wear or aging, it shall be replaced in time.

Cleaning filter: the filter in the gear pump is used to filter impurities and solid particles in the liquid to prevent them from entering the pump body and damaging the gear. Clean and replace the filter regularly to maintain good filtering effect.

Inspection and fastening bolts: check whether the fastening bolts of the gear pump are loose, especially the bolts connecting key components. If the bolt is found to be loose, it shall be fastened in time. ASL electrostatic oil filter

Check the bearing: regularly check the bearing condition of the gear pump, including the lubricating oil condition, wear and noise. If the bearing is found to be seriously worn or has abnormal noise, it should be replaced and repaired in time.

Check the gear and axial clearance: regularly check whether the gear and axial clearance are normal, and timely adjust and repair them. Excessive clearance will reduce the efficiency and performance of the gear pump.

Pay attention to the pump body temperature: pay attention to the change of pump body temperature during operation. If the temperature is too high, it may be that the oil pump is not smooth or there is a problem with the bearing, and the fault should be eliminated in time. IDEX

Clean the cooler regularly: the cooler is an important part of the gear pump, which is used for heat dissipation and temperature reduction. Clean the dust and sundries on the cooler surface regularly to ensure its heat dissipation effect.

Routine inspection of motor: the motor is the key equipment to drive the gear pump, and the working condition of the motor, such as motor temperature, motor current, etc., shall be inspected regularly. If any abnormality is found, it shall be repaired or replaced in time.

Shutdown maintenance: the gear pump shall be shutdown for maintenance when it is not used for a long time. It includes emptying the liquid in the pump body, cleaning the pump body and accessories to prevent rust and scaling.

Pay attention to safety: pay attention to personal safety and equipment safety during maintenance. Be sure to cut off the power supply to avoid accidents. IMO agent

The above are some common measures for the maintenance of VIKING gear pump. Each specific gear pump may have different characteristics and requirements. Therefore, when carrying out maintenance, it is necessary to operate according to specific equipment instructions and operation manuals, and strictly comply with relevant safety regulations. Proper maintenance can effectively extend the service life of the gear pump and ensure its normal operation.