VIKING gear pump It is a common industrial pump, which is often used to transport liquid, liquid or semi-solid materials in industrial production. However, due to long-term use or improper operation, Viking Gear pump Failure may occur, affecting production efficiency. Therefore, it is very important to master the troubleshooting and maintenance skills of Viking gear pump to maintain normal production operation. COLFAX agent

Common faults and solutions (1) The pump cannot be started: check whether the power supply is normal, whether the fuse is blown, and whether the switch is in good contact; If the above checks are normal, it may be that the motor is faulty, and maintenance personnel need to be contacted for inspection, replacement or repair. (2) The pump does not discharge water or the flow decreases: first, check whether the inlet and outlet pipes are blocked, and if so, clean the blockage; Secondly, check whether the speed of the pump is normal, and check whether the impeller of the pump is worn. If worn, it needs to be replaced; In addition, pay attention to whether there is water leakage in the pump. If there is, check whether the seals are intact and replace them in time. (3) The pump temperature is too high: this may be caused by insufficient lubricating oil in the pump or wear of pump body parts. It is necessary to check whether the lubricating oil is sufficient, and pay attention to the timely replacement of worn pump body parts. (4) Excessive noise of the pump: it may be that the internal parts of the pump are severely worn, and maintenance personnel need to be contacted for inspection, replacement or repair; At the same time, you can also check whether the pump foundation is firm to reduce noise. (5) Pump oil leakage: This may be caused by the damage of the pump seal. It is necessary to check and replace the seal to ensure that there is no leakage at the seal. CIRCOR SECCO

Maintenance skills (1) Regular inspection: regularly check the working condition of Viking gear pump, including the speed, flow, temperature, etc. of the pump, find and deal with problems in time to avoid greater failures. (2) Reasonable maintenance: regularly replace the maintenance parts of the pump, such as seals, lubricating oil, etc., to ensure the working effect and life of the pump and avoid unnecessary failures. (3) Follow the operating instructions: When operating Viking gear pump, strictly follow the operating instructions, and do not arbitrarily adjust the pump parameters to avoid affecting the normal operation. (4) Attention to lubrication: pay attention to filling lubricating oil at the gear and bearing of the pump to ensure its normal operation. At the same time, pay attention to the selection of oil products when changing lubricating oil, and use qualified lubricating oil. Viking

To sum up, it is very important to master the troubleshooting and maintenance skills of Viking gear pump to ensure the normal operation of production. Only through regular inspection, reasonable maintenance, following the operating procedures and paying attention to lubrication and other methods can the pump faults be found and handled in time to ensure that the pump is always in good working condition, improve production efficiency and reduce production costs. Therefore, it is recommended that during the use of Viking gear pump, the understanding of its fault handling and maintenance skills should be strengthened, and corresponding measures should be taken according to the actual situation to ensure its normal operation. ASL electrostatic oil filter