VIKING gear pump It is a common industrial equipment, used to transport various liquid media. In daily use, due to various reasons, the pump may fail and needs timely maintenance. Now I will introduce some VIKING Gear pump Common faults and maintenance methods of.

Pump shaft seal oil leakage: pump shaft seal oil leakage is a common fault phenomenon, usually caused by seal wear, aging or improper installation. The solution is to replace the sealing elements to ensure correct and tight installation.

High pump noise: if the pump is abnormally loud during operation, it may be caused by wear or imbalance of internal parts of the pump. The solution is to check the internal parts of the pump. If there are damaged or severely worn parts, they should be replaced in time.

Decrease of pump output flow: if the pump output flow decreases, it may be caused by blockage of the feed pipe, damage of the impeller inside the pump or increase of liquid viscosity. The solution is to clean the feed pipe, replace the impeller or adjust the liquid viscosity.

Unstable pump operation: if the pump is unstable during operation, it may be caused by inlet bubbles, unstable feed pressure or loose internal parts of the pump. The solution is to eliminate the inlet air bubbles, adjust the feed pressure or fasten the internal parts of the pump. ASL electrostatic oil filter

The pump temperature is too high: if the temperature is too high when the pump is running, it may be caused by too much heat generated by the internal friction of the pump or poor cooling system. The solution is to check the internal lubrication of the pump, replace the lubricating oil or repair the cooling system.

To sum up, the maintenance methods of VIKING gear pump mainly include replacing seals, checking the internal parts of the pump, cleaning the feed pipe, replacing the impeller, adjusting the liquid viscosity, removing inlet bubbles, adjusting the feed pressure, tightening the internal parts of the pump, checking the lubrication, replacing lubricating oil, repairing the cooling system, etc. During maintenance, attention should be paid to safe operation to ensure the normal operation of the pump. I hope the above content is helpful to you. IDEX