VIKING gear pump It is a common industrial pump and is widely used in various industrial fields. Correct installation and commissioning Gear pump It is critical for its normal operation and performance. The following details how to correctly install and commission the VIKING gear pump.

1、 Preliminary work for installing gear pump

Understand the basic structure and working principle of gear pump, and be familiar with its technical parameters and performance characteristics.

Determine the installation position and fixing method of the gear pump to ensure its stable and reliable installation position.

Check the appearance of the gear pump to ensure there is no damage and deformation, and clean the external surface.

Prepare required tools and equipment, including screwdrivers, wrenches, jacks, etc.

2、 Installing gear pump

First, place the gear pump in the installation position to ensure that it is symmetrical with the axis of the driving equipment (such as motor or engine).

Use a screwdriver and a wrench to fix the gear pump on the mounting base, and be careful not to tighten or loosen it too much.

After installing the gear pump, check the tightness of each connection to ensure that there is no looseness.

3、 Commissioning gear pump

Before starting the gear pump, check the lubricating oil of the gear pump and the driving equipment, and fill the proper amount of lubricating oil as required.

Start the driving equipment and make it run at normal operating speed. ASL electrostatic oil filter

Observe whether the gear pump rotates smoothly, and check whether there is abnormal vibration and noise.

Check the sealing performance, check whether the sealing device of the pump is tight and whether there is leakage.

Check whether the outlet pressure and flow of the gear pump meet the requirements, and adjust if necessary.

Carry out working performance test on gear pump, such as pumping performance test, high temperature operation test, etc., to ensure its normal operation.

Check and maintain the gear pump regularly to keep it in good working condition. IDEX

Pay attention to the following points when installing and commissioning VIKING gear pump:

Follow the relevant installation and commissioning guidelines to ensure the accuracy and safety of the operation.

Pay attention to the operating environment of the gear pump to avoid its poor working conditions and external interference.

During installation, pay attention to the connection between the gear pump and other equipment or pipes to ensure that they are firmly and tightly connected without leakage.

During commissioning, carefully observe the working condition of the gear pump, and shut down for maintenance in case of any abnormal phenomenon. IMO agent

To sum up, the correct installation and commissioning of VIKING gear pump is the key step to ensure its normal operation and performance. Only by operating in accordance with the relevant operating guidelines and requirements, and installing and debugging properly, can the gear pump play a good role in the work. At the same time, the gear pump shall be regularly inspected and maintained during daily use, and fault handling and maintenance shall be carried out in time to extend its service life.