VIKING gear pump It is a commonly used centrifuge Gear pump , widely used in chemical, petroleum, pharmaceutical, food and other industries, mainly used to transport various liquids. In order to ensure the normal operation and prolong the service life of the gear pump, it is very important to carry out regular maintenance. The maintenance and servicing methods of VIKING gear pump will be introduced in detail below.

Clean the pump body: regular cleaning of the pump body is the key to maintain the normal operation of the gear pump. First, it is necessary to close the inlet and outlet valves of the pump, remove the pump housing, and remove the residues and impurities on the pump cavity and gear. Suitable solvent or detergent can be used for cleaning to ensure that the pump body is clean and free of impurities.

Lubricating gear: gear is the core part of gear pump, and whether it is lubricated normally has a great impact on its performance. CIRCOR SECCO The gear shall be lubricated regularly, and the gear surface shall be lubricated with suitable lubricating oil. When injecting lubricating oil, pay attention to establishing lubricating film on the gear journal to reduce friction.

Check the seal: the quality of the seal directly affects the pumping performance of the gear pump, and the wear and aging degree of the seal should be checked frequently. When replacement is required, the sealing elements that meet the requirements shall be selected and the installation shall meet the standards.

Check the bearing regularly: the bearing is an important part to support the normal operation of the gear pump. Regularly check the lubrication and wear of bearings, Viking Replace the severely worn bearings in time. When replacing the bearing, the bearing seat and bearing hole shall be carefully cleaned to ensure the normal installation of the bearing.

Check the shaft seal of the pump: the shaft seal is the key part to prevent the liquid inside the pump from leaking out. Regularly check the sealing condition of the shaft seal. If leakage is found, the shaft seal shall be replaced and adjusted in time. At the same time, the lubrication state of the shaft seal shall be maintained to ensure its normal operation.

Clean the filter: the liquid entering the pump chamber of the gear pump may contain impurities and particles, ASL electrostatic oil filter These impurities and particles may damage the internal parts of the gear pump. The filter needs to be cleaned and replaced regularly to ensure that the liquid entering the pump chamber is clean.

Monitor the operation of the pump: regularly monitor the operation of the gear pump, including the monitoring of flow, pressure, temperature and other parameters. Through monitoring, the possible problems of the gear pump can be found and solved in time to prevent the occurrence of faults.

Regular maintenance of the motor: the operation of the gear pump cannot be separated from the drive of the motor. Regular maintenance of the motor is an important measure to ensure the normal operation of the gear pump. Check the insulation condition of the motor, the lubrication condition of the bearing and the heat dissipation effect to ensure that the motor works normally.

Study and understand the use and maintenance manual of the gear pump: the use and maintenance manual of the gear pump contains detailed use and maintenance methods. You should carefully study and understand the contents of the manual, and operate according to the requirements of the manual to ensure the normal operation of the gear pump and extend its service life.

In a word, maintenance is very important when using VIKING gear pump. Regular cleaning of pump body, lubrication of gears, inspection of seals, bearings and shaft seals, cleaning of filters, monitoring of pump operation, maintenance of motors and other measures can ensure the normal operation of gear pumps and extend their service life. IDEX At the same time, carefully study and understand the use and maintenance manual of the gear pump, and operate as required, which is also an important means to ensure the normal operation of the gear pump.