ALLWEILER screw pump It is a commonly used industrial pump, which is used to transport various liquids and viscous media. Since the working environment of the pump will affect the performance and service life of the pump Screw pump It is necessary to meet some specific requirements and precautions. The following will describe in detail ALL Installation requirements of WEILER screw pump.

First of all, before installing ALLWEILER screw pump, it is necessary to prepare the required tools and equipment, and ensure that the installation site is clean, tidy and well ventilated. Next, follow the steps below to install:

Install the base: firstly, confirm the flatness of the base to ensure that there is no obvious concave and convex on the base. Then fix the base on the ground of the installation site and fix it with washers and bolts. When installing the base, pay attention to make the base parallel to the flange to avoid distortion or additional stress on the base.

Install the motor: install the motor on the connecting shaft of the pump and fix it. When installing the motor, ensure that the axial direction of the motor and the pump shaft is consistent, and check whether the fastening bolts of the motor are tightened.

Pipe installation: according to actual needs, connect the inlet pipe and outlet pipe, and use flange and sealing gasket for connection. Before connecting the pipeline, ensure that there are no sundries in the pipeline to avoid affecting the normal operation of the pump. At the same time, pay attention to the pipeline routing and support to avoid excessive tension and vibration.

Installation seal: The ALLWEILER screw pump manufacturer uses mechanical seal, so special attention shall be paid to the selection and installation of seal during installation. Ensure that the mechanical seal is installed correctly, and the sealing surface is free of scratches and wear, and lubricate the mechanical seal before installation.

Install valves: according to the actual needs, install appropriate valves on the inlet and outlet pipes to adjust and control the flow of liquid. When installing the valve, pay attention to the opening and closing directions of the valve, as well as the stability and tightness of the valve.

Connecting the conveying system: according to the actual needs, connect the pump to the conveying system to ensure the reliability and tightness of the connection. When connecting the conveying system, pay attention to the support and fixation of the pipeline to avoid adverse effects on the pump due to pipeline vibration.

Test run: after the above installation steps are completed, test run the pump to ensure the normal operation of the motor and pump. Before the test run, check whether the running direction of the motor is correct, and check whether the various indicators of the pump meet the requirements, such as flow, head, etc.

To sum up, the installation requirements of ALLWEILER screw pump mainly include the installation of the base, the installation of the motor, the connection of the pipeline, the installation of the seal, the installation of the valve, and the connection of the conveying system. During installation, pay attention to keeping the installation site clean and tidy, and ensure the reasonable use of tools and equipment. After installation, trial operation must be carried out to ensure the normal operation of the pump. By carefully following these installation requirements, we can ensure the stability and reliability of ALLWEILER screw pump agents and extend their service life.