Screw pump It is a common fluid conveying equipment, suitable for conveying media with high viscosity, high temperature, easy crystallization or easy solidification. The correct use of screw pump can improve the service efficiency and life of equipment, reduce the failure rate and ensure the stable operation of the production process. Now I will introduce how to use the screw pump correctly:

First, read the product manual carefully before installing the screw pump to understand the pump structure, working principle, technical parameters, etc. The installation shall be carried out according to the requirements in the instructions to ensure that the installation position is horizontal, the foundation is firm, and the inlet and outlet pipelines are correctly connected.

Before the pump runs, check the oil level and filling condition of the lubricating oil to ensure that the lubricating oil is sufficient. At the same time, check whether the inlet and outlet valves of the screw pump are open and whether the medium in the pump meets the requirements.

Before starting the screw pump, first open the inlet valve of the pump, gradually start the motor, and then open the outlet valve to slowly increase the pump speed. The speed of the pump cannot be changed suddenly, but should be increased gradually.

During the operation of the pump, the operating state of the pump shall be observed at all times to ensure that the rotor is free of jamming, abnormal noise and good lubrication. In case of any abnormality, stop the machine for inspection and handling in time. IMO agent

Regularly check the sealing parts of screw pump, such as shaft seal, sealing ring, etc., to ensure good sealing performance. At the same time, pay attention to the lubrication of bearings and gear transmission parts, and do a good job in lubrication maintenance.

Clean the interior of the screw pump regularly to remove residual dirt and keep the pump clean. When the pump is out of service for a long time, the medium should be discharged to keep the pump dry and avoid rust.

In case of medium replacement or maintenance, stop the machine for treatment first, and do not disassemble the equipment under pressure. In the process of maintenance, it should be carried out in accordance with the operating procedures and should not be changed at will.

In short, use correctly IMO screw pump It is necessary to carefully implement the requirements of the product manual, do a good job in the installation, operation and maintenance of the equipment, and ensure the normal operation of the equipment. Only in this way can we maximize the efficiency of the screw pump, improve production efficiency and ensure the stable operation of the production process. ALLWEILER