IMO screw pump It is a kind of commonly used industrial equipment, which is used to transport special media such as high viscosity, corrosive, flammable, explosive, etc. To ensure operation safety, the following are some operations IMO Screw pump Specific steps and precautions.

Safety device inspection Before operating the screw pump, first check whether the safety device of the screw pump is intact and available. Including pressure gauge, thermometer, lubrication system, pressure relief valve, protection device against dry running, etc. Ensure that these safety devices are within the normal operating range.

Equipment environment inspection Check the environment around the equipment to ensure that the operation area is clean and well ventilated, and avoid the hazards caused by sundries blocking the operation or leakage.

Personnel must wear protective equipment when operating the screw pump. Including safety helmet, safety glasses, protective gloves, protective clothing, etc. Depending on the characteristics of the media, it may also be necessary to wear gas masks, protective shoes, etc. IMO agent

Understand the working principle and operating steps of the equipment Before operating the screw pump, you must understand the working principle and operating steps of the equipment. This includes the components, operation mode, working principle and common troubleshooting measures of the screw pump.

Pressure relief and evacuation Before operating the screw pump, ensure that the system is depressurized and evacuated. Especially for the operation of flammable and explosive media, special care should be taken. Pressure relief and evacuation must be carried out in accordance with relevant regulations. ALLWEILER

Preparation before operation Before formal operation, the following preparations should be made:

Check the working condition of electrical equipment and instruments to ensure that there is no fault.

Check whether the supply of lubricating oil and cooling water is sufficient.

Release the locking and maintenance status of the equipment.

Turn the equipment switch to the "OFF" position and disconnect the power supply.

Equipment operation During the operation of screw pump, the following items shall be noted:

Start the pump slowly and gradually increase the speed and load.

Regularly observe the operation of the equipment, and pay attention to whether there is abnormal sound, vibration, etc.

Regularly check the lubrication system and cooling system of the equipment to keep them in normal working condition.

Observe the working condition of the motor to ensure its normal operation.

Shutdown operation Before shutdown, the following steps must be followed:

Gradually reduce the load and speed to gradually stop the pump.

Disconnect the power supply and switch off the power switch.

Turn off the lubrication and cooling system.

Clean the equipment and restore it to normal state.

Routine maintenance and upkeep Regular maintenance and upkeep of equipment is the key to ensure safe operation. It includes regular replacement of lubricating oil, inspection of fastening of fasteners, inspection of wear of seals, etc.

Accident emergency treatment During the operation of screw pump, accidents may occur. Such as pump leakage, media splash, etc. In case of an accident, emergency measures must be taken immediately, and relevant personnel must be reported for support. ALLWEILER screw pump

In a word, when operating IMO screw pump, you must strictly follow the operating procedures, keep alert at all times, and ensure your own safety and the normal operation of the equipment.