ALLWEILER screw pump It is a commonly used centrifugal pump, and its parameter setting plays a vital role in the normal operation and performance of the pump. In correct configuration ALL WEILER Screw pump Before the parameters of, we need to understand the screw pump and its working principle, and set the parameters according to the specific working conditions.

ALLWEILER screw pump is a positive displacement pump. The liquid is sucked in from the inlet through the rotating screw and discharged along the screw cavity. Before setting parameters, we need to determine the following key parameters:

Flow: Determine the flow required by the screw pump according to the needs in the work scenario. The flow is generally obtained through calculation or measurement, and can be directly set in the parameters of the screw pump.

Head: The head refers to the height required for the pressure increase of liquid in the pump, which can also be understood as the pressure difference required for the liquid from the inlet to the outlet of the pump. The head is closely related to the flow. After the flow is determined, the required head can be calculated. According to the size of the lift, the speed and steering of the screw pump can be adjusted to meet the requirements of the system for pressure and flow.

Pump speed: ALLWEILER screw pump manufacturer's speed refers to the number of revolutions of pump rotor per minute. The setting of pump speed is closely related to the actual working scenario. Generally, the higher the speed, the greater the flow, but the head will drop. Therefore, when setting the pump speed, it is necessary to comprehensively consider the requirements of flow and head, and select according to the actual working conditions.

Temperature: the temperature of the liquid when the screw pump is working is also an important parameter to be considered. The viscosity of different liquids at different temperatures will change, affecting the working effect of the screw pump. Therefore, the proper viscosity and pump material should be selected according to the temperature range of the liquid when setting parameters.

Material selection: according to the nature and temperature of the liquid, select the appropriate pump material to ensure that the pump can operate normally and has a long service life.

When setting parameters, we can refer to the product manual and technical specifications of ALLWEILER screw pump. The specific parameter setting can be determined through practice and experiment, or consult the manufacturer or professionals for suggestions.

In addition to the main parameters mentioned above, ALLWEILER screw pump also has some other parameters to set, including: pump inlet and outlet diameters, sealing method, motor power, inlet pressure and outlet pressure, etc.

After the parameter setting is completed, we also need to conduct a series of parameter tests and adjustments to ensure the normal operation and performance of the pump. These tests can include flow, head, pump speed and other aspects of detection.

The correct configuration of ALLWEILER screw pump agent parameters has an important impact on the pump performance and service life. Therefore, when setting parameters, it is necessary to comprehensively consider the working requirements, liquid properties, working temperature and other factors, and use technical support and practical experience to ensure that the screw pump can work normally and has a long service life.