application
LKH UltraPure pump is an efficient, economical and practical centrifugal pump, which meets the requirements of the pharmaceutical industry. It can handle the product gently and has chemical stability. There are five models of LKH UltraPure: LKH UltraPure-10, - 20, - 25, - 35 and - 40. The standard design (standard configuration) LKH UltraPure comes with a 45 ° outlet (counterclockwise). TD 234-05445 ° outlet This pump is designed for CIP and SIP, with large internal chamfers and cleanable seals.
technical data
Material Science
Steel parts of over-current products: W. 1.4404 (316L), material can
Traceability 3.1 in accordance with EN 10204
Other steel parts: stainless steel.
Seals for overflow products: EDPM - USP Category 6.
Surface finish of over-current products: Bright (Ra 0.5 µ m)
Pump housing, surface finish: Bright (Ra 0.8 µ m)
electric machinery
Standard motor with base flange, according to IEC metric standard, 2 poles at 50/60 Hz=3000/3600 rpm, IP 55 (drain hole with steam seal plug), insulation class F.
Rated power of motor
50 Hz： . . . . . . . . . . . . . . 1.5 - 22 kW。
60 Hz： . . . . . . . . . . . . . . 1.75 - 25 kW。
guarantee
LKH UltraPure centrifugal pump series has an extremely long 3-year warranty. This warranty covers all non wearing parts with original Alfa Laval spare parts.
Operation data
pressure
Maximum inlet pressure: Static: 1000 kPa (10 bar).
temperature
Temperature range:- 10 ° C to+140 ° C (EPDM).
Noise level
Noise level (at 1 m): 60 - 80 dB (A)。
Double ended mechanical seal
Water pressure: 500 kPa (5 bar) maximum.
Water consumption: 0.25 - 0.5 l/min。
Options
A. Reduced diameter impeller.
B. Applicable to motors of other voltages and/or frequencies.
C. 1500 rpm motor.
D. Motors with higher safety/explosion-proof rating.
E. Double ended mechanical shaft seal.
F. Pump (with guard).
G. Pump (without bracket).
H. No drain
1. Steel parts of over-current products - ferrites up to 5%
J. Certificate of surface finish.
K. Surface finish of overcurrent product Ra 0.8 µ m
50. Surface finish of overcurrent product Ra 0.5 µ m+electric polishing
-After electric polishing, the final surface finish value will change.
M. FPM or FEP over-current product seal.
N. Special water injection configuration, including 1/2 diaphragm valve, needle valve and flowmeter.
O. Water pressure test with certificate
P. Passivation
Q. 0 ° outlet, see the figure below.
Standard file combination:
-3.1 Certificate (according to EN10204)
-FDA compliance certificate for rubber pad of over-current products.
-USP Class 6 Compliance Certificate - EPDM only
-Pump Performance Test Certificate
order
Please specify the following when ordering:
-Pump model.
-Connection mode.
-Impeller diameter.
-Motor rated power.
-Voltage and frequency.
-Flow, pressure and temperature.
-Density and viscosity of the product.
-Option.
be careful!
See also IM 70831 for further details. This product has EHEDG certificate
Recommended reading: ALLWEILER , ALL Authorized agent of WEILER, ALLWEILER Screw pump
